To use: Wear protective gloves to prevent staining of skin. Test on a small patch before proceeding. Shampoo the animal, then apply to wet fur or hair and leave on for 15 minutes (more time increases color intensity). Rinse and dry coat. Note: for coloring limited areas, such as ears or tail, you may apply to dry fur. Results may vary, depending on application strength and individual pets coat.
For manes and tails we recommend the following tips:
1. Apply a thick coat of coat conditioner to hair under mane or on hocks, then lay plastic wrap over areas you want to remain uncolored.
2. Section by section, slightly dampen hair with a spray bottle of water, and work dye through with gloved fingers, being careful to use only as much dye is needed for coverage.
3. Carefully, bag tail or locks of mane into plastic bags and tie loosely. This will prevent dripping or switching onto uncolored fur. Wait about 15 minutes. 4. Working quickly, rinse each section thoroughly. Shampoo neck or hocks to remove excess conditioner and any errant dye.
Ingredients: Purified water, CTFA*-approved dyes and pigments, cellulose thickener, glycerine and preservative.
CAUTION: Do not ingest, or allow pets to lick or ingest. Do not use on pets that have sensitive, irritated, or damaged skin. Avoid contact with eyes and mouth; if contact occurs, flush with a large amount of water for 15 minutes, and consult a veterinarian if irritation occurs and persists.
WARNINGS: Although this produce is nontoxic and CTFA approved, in rare cases it may potentially cause allergic reactions, pain, or itchingâ€”if any of these occur, discontinue use immediately, rinse, and consult a veterinarian.
KEEP OUT OF REACH OF CHILDREN
Store in a cool, dry place away from excessive heat.